Taranis Refines Drilling Targets at Horton
FOR IMMEDIATE RELEASE
Taranis Resources Inc.
681 Conifer Lane
Estes Park, Colorado
80517
www.taranisresources.com
Taranis Refines Drilling Targets at Horton
Estes Park, Colorado, March 25, 2025 – Taranis Resources Inc. (“Taranis” or the “Company”) [TSX.V:
TRO, OTCQB: TNREF] is providing additional information from the 2024 exploration work at Thor that
was conducted in addition to the deep drilling. In the fall of 2023, a number of high -grade boulders were
found at surface , and t he results of that boulder sampling were summarized in a News dated November
6/2023. In the summer of 2024, Taranis completed systematic exploration activity in this area including the
completion of a soil sampling grid, further boulder sampling, magnetometer/Very Low Frequency (“VLF”)
surveys and three short diamond drill holes. This area is considered highly prospective because it lies west
of the Ripper Fault, that demarks the westernmost area where the epithermal deposit occurs at Thor. It also
occurs within an area that is located uphill of the known Thor deposit making it likely the mineralized float
samples in this area are not related to the existing epithermal deposit. Within the Ripper Fault itself located
on the east side of Horton, a high-grade gold & silver occurrence called Gold Pit was found that includes
channel sample results of 6.38 g/t Au, 576 g/t Ag, 0.031% Cu, 7.6% Pb, 0.11% Zn and 0.14% Sb over
0.66m (See Taranis News Release dated November 28, 2022)
Soil Sampling
A total of 204 soil samples were collected with a soil auger in a systematic grid that covered the Horton
area. This area has no outcrop, and soil sampling is a n effective method to isolate the source of the high -
grade boulders. The soil sampling identified seven potential sources for the mineralized boulders, but two
of these (Targets 2 & Target 3) appear to have high importance (see attached map).
Surface Grab Sampling
Additional surface grab sampling (47 samples) was undertaken in the Horton Area, and this continued to
document a number of high -grade boulders. (See Taranis News Release dated November 6, 2023). Some
of the select results of the 2024 grab sampling are shown in the table below.
Select 2024 Grab Sample Results from Horton Area
Sample
No.
Hand Sample Description Au
(g/t)
Ag
(g/t)
Cd
(ppm)
Cu
(%)
Pb
(%)
Zn
(%)
Sb
(%)
S
(%)
3241321 Chalcedonic boulder, blood red, 5% vugs, very hard. 0.83 13.8 Tr. Tr. Tr. 0.00 0.00 -0.3
3241322 Massive coarse-grain pyrite in quartz vein (50% quartz,
50% pyrite)
2.87 11.0 0.4 0.01 0.01 0.00 0.00 24.0
3241323 Heavily oxidized gossan - 30% ankerite 30% quartz 8%
pyrite, possible other sulphide.
7.32 888.0 17.2 1.27 0.04 0.16 0.32 8.9
3241324 80% q uartz 20% bubbly black appearance numerous
vugs, oxidized. Highly gossanous.
6.00 75.7 0.7 0.05 0.08 0.01 0.02 0.5
3241328 Very vuggy q uartz, abundant vugging, heavy Fe Ox,
yellow colour.
3.33 54.4 0.1 0.01 0.28 0.01 0.01 0.5
3241333 Extremely gossanous rock, sediment? with numerous
small quartz veinlets with galena/tetrahedrite.
3.55 324.0 33.2 0.47 4.17 2.28 0.22 1.9
2
3241345 Massive grey quartz, with chalcedonic quartz vein 2 cm
wide, weathered.
4.64 295.0 0.9 0.04 0.06 0.01 0.01 1.2
3241044 Massive pyrite & tetrahedrite. 14.55 1,045 42.7 3.23 0.05 0.43 3.17 43.4
3241045 Quartz/sediment breccia with vugging. 1.05 292.0 0.9 0.07 0.08 0.01 0.44 0.5
3241046 Banded pyrite with tetrahedrite clots. 3.28 470.0 19.6 1.17 0.28 0.23 0.71 29.7
3241047 Quartz/sediment breccia with dodecahedral pyrite (5%)
and early-phase pyrite.
1.88 13.7 0.5 0.03 0.02 0.01 0.02 9.4
3241050 Very weathered, silver-color sulfide., extensive
vugging.
6.31 1,705 3.5 0.24 2.40 0.04 0.84 16.3
3241352 Gossan, greywacke with q uartz stringers, FeOx,
tetrahedrite.
1.24 853.0 10.1 0.42 8.89 0.83 0.39 2.5
3241357 Vuggy FeOx SIF-type boxwork, 'frothy' texture. 6.44 286.0 1.9 0.13 0.03 0.02 0.80 1.9
Grab sampling is not representative of potential subsurface mineralization in the area as the source of the
grab samples is unknown, and it is not known how far the boulders have been displaced from their source.
However, when the grab samples are interpreted in conjunction with soil samples and other data such as
geophysical surveys it can provide further targeting information - particularly in areas where mineralized
surface grab samples are underlain by soil geochemical anomalies with similar geochemical signatures. One
of the unique aspects of the grab samples taken at Horton in 2024 (and 2023) is the general lack of zinc and
lead, and this suggests a different origin than the Thor epithermal deposit that is enriched in these metals.
VLF and Magnetic Surveys
Geophysical surveys were undertaken on the soil sampling grid, and the ground magnetometer survey was
able to identify a circular feature that is spatially related to Target areas 3 and 4. This feature is weakly
defined, but it does appear to correlate with other circular features identified on satellite images of the area.
Targets 2 and 3 appear to originate from the center of this feature. The VLF surveys show two parallel
conductive anomalies that originate from the center of Area 3 and extend to the northwest, including one
strong VLF conductor located in Target 3.
Diamond Drilling
Three short diamond drill holes were completed on a pre-existing road that transects the Horton Area. These
drill holes were not targeted on any specific features and were designed to provide depth to bedrock in the
area as well as outlining rock units below colluvium.
‘Scout’ Drill Holes Horton Area
Hole Easting Northing Azimuth Dip Depth (m) Colluvium
Depth (m)
Thor-243 464,700.2 5,616,432.4 0.0 -90.0 100.3 9.3
Thor-249 464,653.7 5,616,334.9 0.0 -90.0 83.2 3.5
Thor-254 464,534.5 5,616,277.9 196.0 -47.0 90.2 9.1
Total/Average 273.7 7.3
Drill holes Thor -243 intersected black (carbonaceous) metasediments and metavolcaniclastic rocks that
contained minor pyrite and localized breccia zones. The depth of the colluvium was 9.3m, and this is
shallow enough that soil sampling should be an effective tool to detect subsurface mineralization. Thor-243
3
intersected bedrock at a depth of 3.5m below the surface , and this drill encountered zones of significant
quartz veining within rocks identical to Thor -243. Drill hole Thor -254 was drilled on the west end of the
Horton access road and encountered 9.1m of colluvium before hitting bedrock. Rocks in this hole were
dominated by metasedimentary and volcaniclastic rocks, and included areas of significant quartz veining
that did not contain appreciable gold or silver.
Comment
John Gardiner, President and CEO of Taranis comments “2024 gave us a much better understanding of the
source of grab samples identified in the Horton Area. A combined approach using soil sampling,
geophysics, boulder sampling and limited diamond drilling has identified two high-priority targets (Targets
2 & 3) that occur within a circular magnetic feature and have corresponding VLF anomalies. If we are able
to successfully identify bedrock-related mineralization in this area and expand the epithermal deposit west
of the Ripper Fault and Gold Pit, this opens up a new exploration area at Thor”.
Quality Control and Laboratory Methods
All samples for the Thor project were securely delivered to Actlabs in Kamloops, British Columbia.
Analytical work was completed both at the Kamloops and Ancaster, Ontario locations. Actlabs is ISO 17025
accredited. Taranis completed two types of geochemical analysis on the drill core.
Soil Samples were collected in the field using a gas-powered auger, and stored in soil sample bags that were
subsequently dried in the field . They were analyzed for 42 ele ments by 4 -Acid Digestion / Inductively
Coupled Plasma - Mass Spectrometry (“ICP-MS”) and for gold by 30g Fire Assay / Atomic Absorption
Spectrophotometry (“AAS”).
Visibly (or potentially mineralized sections of core) were systematically sampled after sawing the
core in half onsite. Samples were analyzed for 42 elements by 4-Acid Digestion / Inductively Coupled
Plasma - Mass Spectrometry (“ICP-MS”) and for gold by 30g Fire Assay / Atomic Absorption
Spectrophotometry (“AAS”). Where overlimit values were enc ountered in the analysis of these samples,
ore-grade’ determinations were made using subsequent ICP analysis and gravimetric methods. As a Quality
Control (“QC”) measure, Taranis also submitted analytical standards into the sample stream every tenth
sample in addition to the laboratory’s own quality control methods.
Qualified Person
Exploration activities at Thor were overseen by John Gardiner (P. Geo.), who is a Qualified Person under
the meaning of Canadian National Instrument 43-101. John Gardiner is the principal of John J. Gardiner &
Associates, LLC which operates in British Columbia under Firm Permit Number 1002256. Mr. Gardiner
has reviewed and approved the comments contained within this News Release.
Taranis currently ha s 100,348,854 shares issued and outstanding ( 113,827,227 shares on a fully -diluted
basis).
TARANIS RESOURCES INC.
4
Per: John J. Gardiner (P. Geo.),
President and CEO
For further information contact:
John J. Gardiner
681 Conifer Lane
Estes Park, Colorado 80517
Phone: (303) 716-5922 Cell:
(720) 209-3049
NEITHER THE TSX VENTURE EXCHANGE NOR ITS REGULATION SERVICES PROVIDER (AS THAT TERM IS
DEFINED IN THE POLICIES OF THE TSX VENTURE EXCHANGE) ACCEPTS RESPONSIBILITY FOR THE
ADEQUACY OR ACCURACY OF THIS NEWS RELEASE.
This News Release may contain forward looking statements based on assumptions and judgments of management regarding
future events or results that may prove to be inaccurate as a result of factors beyond its control, and actual results may differ
materially from expected results.
5