PWM.V · 2019-01-10 12:00:00

Power Metals Announces Planned Drill Program at Paterson Lake

Exploration Programs

VANCOUVER

Jan. 10, 2018

/CNW/ -

Power Metals Corp.

" or the "

Company

") (TSX VENTURE:PWM)

(FRANKFURT:OAA1)(OTC:PWRMF) is pleased to announce that it has started planning for a drill program at Paterson Lake, 60 km north of

Kenora

, northwestern

Ontario

. Power Metals has an approved Exploration Permit from Ontario Ministry of Energy, Northern Development and

Mines for drilling at Paterson Lake.

Figure 1 Geology map of Marko’s, Jesse’s and other petalite pegmatite occurrences in Separation Rapids Greenstone Belt, northwestern

Ontario. (CNW Group/POWER METALS CORP)

Power Metals has two lithium drill targets at Paterson Lake located along two parallel northeast-southwest petalite pegmatite trends (Figure 1):

Marko's pegmatite

Jesse's pegmatite

Highlights of Marko's pegmatite include:

over

268 m

strike length on surface

3.36 to 4.43 % Li

O range for 13 grab samples.

559 to 1398 ppm Ta range for 5 grab samples

19 historic drill holes on Power Metals' Paterson Lake Property

historic drilling showed that there is both Lithium and Tantalum mineralization at depth on the Marko's pegmatite and it is not just one

pegmatite dyke but two: Marko's and North Marko's.

The Marko's pegmatite is one of the top three pegmatites for Lithium and Tantalum mineralization in the Separation Rapid Greenstone Belt and is

drill ready. On surface, Marko's pegmatite is along the contact of an iron formation and gabbro ridge. The historical drilling did not test the

western extension of the Marko's pegmatite which is open along strike. It should be relatively easy to follow the edge of the iron formation and

gabbro ridge to extend the strike length of the Marko's pegmatite.

Highlights of Jesse's pegmatite (Figure 2):

discovered in

June 2018

by Power Metals geologists

consists of at least 4 parallel east-west trending dykes exposed on surface: North, Between North and Jesse's, Jesse's and South Dykes

190 m

between North and South Dykes

1.01 to 3.26 % Li

O for 12 grab samples

Up to 271 ppm Ta in grab samples

All of Jesse's petalite dykes are deformed and sheared similar to that at Avalon's Separation Rapids Lithium Property located 3.7 km to the

west. The dykes are characterized by recrystallization textures and banding. The pegmatite dykes are hosted by metasedimentary and mafic

metavolcanics rocks which occur along ridges. The pegmatite dykes are zoned with fine-grained aplite outer zones enriched in Ta and coarse-

grained petalite-K-feldspar-quartz-muscovite with trace garnet core zones enriched in Li. Stripping is recommended to extend the strike length of

each dyke.

Jesse's Dykes all have the same roughly east-west strike as the other pegmatites in the Separation Rapids Greenstone Belt. Jesse's, Rhea's

and Cook's pegmatites are along the same contact between mafic metavolcanics and metasediments as other petalite pegmatites historically

mapped by Ontario Geological Survey: Draven, Black Bear, Ballpeen, Pegmatites # 5, 6, 7, 8, 9, 10 and 11.

About

236 m

west of Jesse's North Dykes, along the same metasedimentary ridge, another petalite pegmatite was discovered with 0.94 % Li

This West Dyke is a possible extension of the North Dykes. This West Dyke has the same mineralogy as Jesse's pegmatite indicating significant

exploration potential to find more petalite dykes along this

236 m

long ridge (Figure 2).

At Jesse's and Marko's pegmatites, petalite is the dominant lithium ore mineral, but spodumene is also present in the dykes. Petalite (LiAlSi

)

is the high temperature lithium aluminosilicate whereas spodumene (LiAlSi

) is the low temperature/high pressure lithium aluminosilicate. Both

petalite and spodumene can be used to produce lithium carbonate and lithium hydroxide for lithium batteries.

Paterson Lake Property occurs within the Separation Rapids Greenstone Belt which is also home to the Big Whopper and Big Mack petalite

pegmatites. Separation Rapids Greenstone Belt is known as the Bird River Greenstone Belt in

Manitoba

which hosts the Tanco pegmatite.

Power Metals' Paterson Lake property consists of 106 cell claims within the Paterson Lake and Treelined Lake Areas. The Property is

approximately 7 km x 3 km in size. Power Metals optioned the Paterson Lake property in 2017 because the property has multiple known petalite

pegmatite dykes on surface, but yet is still underexplored.

Dr. Selway, VP of Exploration, stated "I am looking forward to a drill program at Paterson Lake on Marko's pegmatite and stripping and drilling

on Jesse's Pegmatite. The last historic drilling on the Marko's pegmatite was in 2002. There is potential to extend both pegmatites along strike."

Paterson Lake

Paterson Lake Property is located in Paterson Lake and Treelined Lake Areas, 60 km north of

Kenora

NW Ontario

close to the

Ontario

Manitoba

border. Paterson Lake Property is located within the Separation Rapids Greenstone Belt and hosts multiple petalite-bearing

pegmatite dykes. The Property was optioned from Exiro Minerals Corp. in 2017 (Power Metals press release dated

April 20, 2017

). Avalon

Advanced Materials Separation Rapids Lithium Project with 8.12 Mt at 1.37 % Li

O measured + indicated resources as of

November 15, 2017

located 1.2 km from the Paterson Lake Property.

Figure 1 Geology map of Marko's, Jesse's and other petalite pegmatite occurrences in Separation Rapids Greenstone Belt, northwestern

Ontario

Figure 2 Map of surface samples colour coded by lithium grade at Jesse's pegmatite, Paterson Lake Property.

Case Lake

Case Lake Property is located in Steele and Case townships, 80 km east of

Cochrane

NE Ontario

close to the

Ontario

Quebec

border. The

Case Lake pegmatite swarm consists of six spodumene dykes: North, Main, South, East and Northeast Dykes on the Henry Dome and the West

Joe Dyke on a new tonalite dome.

Qualified Person

Julie Selway

, Ph.D., P.Geo. supervised the preparation of the scientific and technical disclosure in this news release. Dr. Selway is the VP of

Exploration for Power Metals and the Qualified Person ("QP") as defined by National Instrument 43-101. Dr. Selway is supervising the

exploration program at Case Lake. Dr. Selway completed a Ph.D. on granitic pegmatites in 1999 and worked for 3 years as a pegmatite

geoscientist for the Ontario Geological Survey. Dr. Selway also has twenty-three scientific journal articles on pegmatites. A National Instrument

43-101 report has been prepared on Case Lake Property and filed on

July 18, 2017

About Power Metals Corp.

Power Metals Corp. is a diversified Canadian mining company with a mandate to explore, develop and acquire high quality mining projects. We

are committed to building an arsenal of projects in both lithium and high-growth specialty metals and minerals. We see an unprecedented

opportunity to supply the tremendous growth of the lithium battery and clean-technology industries. Learn more at

www.powermetalscorp.com

ON BEHALF OF THE BOARD,

Johnathan More

, Chairman & Director

Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in policies of the TSX Venture Exchange)

accepts responsibility for the adequacy or accuracy of the content of this news release.

No securities regulatory authority has either approved or disapproved of the contents of this news release. The securities being offered have

not been, and will not be, registered under the United States Securities Act of 1933, as amended (the "U.S. Securities Act"), or any state

securities laws, and may not be offered or sold in the

United States

, or to, or for the account or benefit of, a "U.S. person" (as defined in

Regulation S of the U.S. Securities Act) unless pursuant to an exemption therefrom. This press release is for information purposes only and

does not constitute an offer to sell or a solicitation of an offer to buy any securities of the Company in any jurisdiction.

Cautionary Note Regarding Forward-Looking Information

This press release contains forward-looking information based on current expectations, including the use of funds raised under the Offering.

These statements should not be read as guarantees of future performance or results. Such statements involve known and unknown risks,

uncertainties and other factors that may cause actual results, performance or achievements to be materially different from those implied by

such statements. Although such statements are based on management's reasonable assumptions, Power Metals assumes no responsibility to

update or revise forward-looking information to reflect new events or circumstances unless required by law.

Although the Company believes that the expectations and assumptions on which the forward-looking statements are based are reasonable,

undue reliance should not be placed on the forward-looking statements because the Company can give no assurance that they will prove to be

correct. Since forward-looking statements address future events and conditions, by their very nature they involve inherent risks and

uncertainties. These statements speak only as of the date of this press release. Actual results could differ materially from those currently

anticipated due to several factors and risks including various risk factors discussed in the Company's disclosure documents which can be

found under the Company's profile on

www.sedar.com

This press release contains "forward-looking statements" within the meaning of Section 27A of the Securities Act of 1933, as amended, and

Section 21E the Securities Exchange Act of 1934, as amended and such forward-looking statements are made pursuant to the safe harbor

provisions of the Private Securities Litigation Reform Act of 1995. The TSXV has neither reviewed nor approved the contents of this press

release.

Figure 2 Map of surface samples colour coded by lithium grade at Jesse’s pegmatite, Paterson Lake Property. (CNW Group/POWER METALS

CORP)

SOURCE

POWER METALS CORP

View original content to download multimedia:

http://www.newswire.ca/en/releases/archive/January2019/10/c4472.html

%SEDAR: 00024408E

For further information:

Power Metals Corp., Johnathan More, 646-661-0409, [email protected]

CO: POWER METALS CORP

CNW 03:05e 10-JAN-19

← Back to feed