Northstar Intersects 31.1 g/t Au Over 0.7m and 15.1 g/t Au Over 0.8m at Planet Syenite
Northstar Intersects 31.1 g/t Au Over 0.7m and
15.1 g/t Au Over 0.8m at Planet Syenite
Vancouver, British Columbia--(Newsfile Corp. - October 9, 2020) -
Northstar Gold Corp.
(CSE: NSG)
("
Northstar
" or the "
Company
")
,
reports drill results from the last 5 holes of a 5,023 metre, 28 hole
Phase I diamond drill program on the Company's 100%-owned Miller Gold Property, situated 18 km
southeast of the town of Kirkland Lake and Kirkland Lake Gold's Macassa SMC gold mine.
The primary objective of the Phase I drill program was to confirm and expand known near surface,
Kirkland-style high grade gold/telluride mineralization and portions of a historic estimate within the No. 1
Vein. The Phase I program not only succeeded in expanding the near surface, high-grade gold
mineralized zone but it also discovered several additional near surface gold zones (Veins 2, 3 and 4 in
the hanging wall of No. 1 Vein, now collectively referred to as the
Allied Syenite Gold Zone
),
highlighting the potential for the delineation near surface bulk tonnage gold mineralization.
Earlier Phase IA and Phase IB drill results reported by Northstar from the No. 1 Vein and Allied Syenite
alkalic intrusive gold system include
18 g/t gold over 3.89 metres
(Drill Hole MG20-34),
19.4 g/t Au
over 4.4m within 118.5m interval averaging 1.4 g/t Au
(Drill Hole MG20-49) and
4.7 g/t Au over
8.0m within a 107.3m interval averaging 1.2 g/t
(Drill Hole MG20-47) (Please see Northstar News
Releases dated June 3
rd
, 2020 and September 2
nd
, 2020).
Planet Syenite Drill Results
The Planet Syenite is located approximately 1.4 km to the northwest of the Allied Syenite, along strike of
the central Catharine Fault Zone structure within a high IP chargeability corridor.
In late July, early August,
2020, Northstar drilled 4 holes targeting high-grade gold-telluride mineralization, following up previous
drill results from the Planet Syenite, a 250 metre elliptical
stock intruding mafic volcanic rocks, central to
a number of intersecting gold-bearing fault, shear and broad quartz stockwork zones on the Miller Gold
Property. Drilling identified a series of stacked silicified zones with quartz veins ranging in apparent
width between 0.3m and 1.6m, hosting visible gold and gold tellurides within the syenite intrusion. Phase
I drill results are highlighted below and confirm the Planet Syenite warrants additional drilling:
Hole MG20-53 intersected
31.1 g/t Au over 0.7m and 15.1 g/t Au over 0.8m, encompassing a
broader silicified zone averaging 1.9 g/t Au over 22.6m between 71.9m and 94.5m;
this hole
confirms the previous drilling results from MG15-24 in the Planet Syenite which intersected 3.32 g/t
Au over 11.55m including 74.9 g/t Au over 0.3m in a similar silicified zone hosting visible gold and
gold tellurides in quartz veins.
A new discovery of gold bearing breccia was made in drill hole MG20-54, adjacent to the Allied Syenite
at a depth of 245m.
This zone averaged
1.7 g/t gold over 5.0m
. A complete listing of Phase IB drill
results for holes MG20-50 to MG20-54 is provided in Table 1 and supporting maps and sections can be
viewed on the Company's website.
"Northstar is very pleased with Miller Gold Property Phase I drill results", states Brian P. Fowler, P.Geo.,
President and CEO of Northstar Gold Corp.
"Phase I drilling confirms the Miller Gold Property hosts a
number of significant, near-surface high-grade gold telluride veins and broad, lower-grade, intrusion-
related gold-telluride stockwork and structures with demonstrable potential for expansion with additional
drilling.
Northstar is positioning to follow-up Phase I drill results and new discoveries with a 4,000 metre,
Phase II drill program scheduled to commence in late October / early November, 2020."
GoldSpot Discoveries Corp. Data Processing, Artificial Intelligence (AI) Driven 3D Modeling and
Exploration Targeting On-going
Phase II drilling will have the added benefit of important geological insights provided by GoldSpot
Discoveries Corp., who are currently processing data from Northstar's $350,000, 2020 3D IP, magnetics
and gravity surveys on the Miller Gold Property and preparing an integrated 3D geology and geophysical
exploration model and targeting study.
Results will be documented in a Technical Report scheduled for
delivery by the end of October."
Phase I Drill Program
Northstar completed Phase I drilling at the Miller Gold Property on August 4
th
, 2020. All drill core has
been logged with samples assayed for gold by AGAT Laboratories in Mississauga, Ontario. Metallic
screening was performed on 65 samples associated with core intervals hosting coarse visible gold or
gold tellurides, including 30 samples from the Planet Syenite with FA-AA samples >0.8 g/t Au from the
Planet Syenite increasing by an average of
111%
in gold content with an average of 67% of the total
gold in the coarse fraction, indicating the presence of very coarse gold in the samples.
Surface Exploration
The Company is fully permitted and will conduct surface stripping in multiple areas of the Property where
visible gold and gold tellurides have been observed, to provide for geological mapping and additional
sampling. Surface stripping has proven to be highly effective in defining new mineralized zones on the
Property as overburden is generally thin. This work will commence in late October.
Miller Gold Property Phase IB drill results are presented in Table 1 below:
Hole
No.
Collar
UTM -
Zone 17
Azimuth
(Degrees)
Dip
Angle
(Degrees)
From
(m)
To (m)
Core
Length
(m)
True
Width
(m)**
Gold
Grade
(g/t)
Comments
MG20-
50
582170,
5318969
200
-50
46.9
incl.
46.9
61
62
incl.
49.5
62
15.1
incl.
2.6
1
0.8
incl.
2.74
3
Stockwork
zone
MG20-
51
582208,
5318998
200
-50
98
150
153
180
99.5
151.5
154.5
181.5
1.5
1.5
1.5
1.5
1.3
1
1.3
0.9
MG20-
52
582244
5318828
350
-45
2.6
16.4
42
53.4
4
17.2
43.5
54.5
1.4
0.8
1.5
1.1
2.48
1.27 *
5
5.4
QV with
Tellurides
1m wide QV
with Tellurides
MG20-
53
582173
5318810
10
-50
24.5
71.9
71.9
91
incl.
91
93.7
139.5
176
25.3
94.5
72.6
94.5
incl.
92.2
94.5
141
188
0.8
22.6
0.7
3.5
incl.
1.2
0.8
1.5
12
2.9
1.9 *
31.1*
5.68 *
incl.
6.4
15.1
*
5.17
0.32
50cm quartz
vein
Silicified zone
with QV's and
VG .
1.6m wide
quartz vein
with VG
Chlorite
veining
Aplite
dikes with py
MG20-
54
582865,
5318047
0
-90
127.5
157
incl.
158
203
237.5
245
incl
245
247
133
159
incl.
159
204.5
239
250
incl.
246
248
5.5
2
incl.
1
1.5
1.5
5
incl.
1
1
5.16
1.27
5.95
incl.
10.8
1.7
1.96
1.67
incl.
2.38
2.7
Vein 1
intercept
Feldspar
Porphyry dike
with py
"
"
"
Coarse
syenite with py
Tectonic
breccia zone
q-c stringers
and py - new
discovery
Hole
No.
Collar
UTM -
Zone 17
Azimuth
(Degrees)
Dip
Angle
(Degrees)
From
(m)
To (m)
Core
Length
(m)
True
Width
(m)**
Gold
Grade
(g/t)
Comments
Visible gold or tellurides* True width unknown where not stated**
Quality Control
Northstar has implemented a quality control program for its Miller Gold Property to ensure best practice
in the sampling and analysis of the drill core, which includes the insertion of blanks, duplicates, and
certified standards into the sample stream. NQ sized drill core is saw cut with half of the drill core
sampled at intervals based on geological criteria including lithology, visual mineralization, and alteration.
The remaining half of the core is stored on-site at Earlton, Ontario.
Drill core samples are submitted to AGAT Laboratories Timmins, Ontario facility for sample preparation
and forwarding to AGAT Laboratories Mississauga Ontario for analyses. Gold analyses are obtained via
industry standard fire assay with atomic absorption finish using 50 g aliquots. For samples returning
greater than 10 g/t gold follow-up fire assay analysis with a gravimetric finish is completed. Based on
initial fire assay gold indications as well as visual indication of mineralization and alteration, intervals are
selected for re-assay by the screen metallic fire assay method. Samples are also analysed for 48 trace
and major elements by ICP-MS following a four-acid digestion. AGAT Laboratories are ISO/IEC
17025:2017 accredited (Lab No. 665) for the preparation and analyses performed on the Miller Gold
samples.
Qualified Persons
The QA/QC program was undertaken by Company personnel and independently monitored by Mr. Gary
Lustig, P.Geo., a 'Qualified Person' (Q.P.) as defined under Canadian National Instrument NI 43-101.
A
secure chain of custody is maintained in storing and transporting of all samples.
Trevor Boyd, PhD, P.Geo., a 'Qualified Person' (Q.P.) as defined under Canadian National Instrument NI
43-101, has prepared and reviewed technical aspects of this news release.
About the Miller Gold Property
The Miller Gold Property and the Kirkland Lake Gold camp share many important geological features
such as similar rock types, gold telluride mineralogy, timing of mineralization and large-scale
hydrothermal gold systems featuring multi-stage and long-lived alkalic magmatic gold deposition. This
strongly suggests the gold mineralization in both regions is derived from a common gold enriched
alkaline magmatic-hydrothermal reservoir at depth and channelled to surface by deep seated,
interconnected structures such as the first order Catharine Fault zone. An important difference is the
Miller Property, in addition to high-grade gold-telluride mineralization, has several near-surface broad,
low-grade bulk-tonnage drill zones (Planet and Allied Syenites) and remains un-explored at depth.
About Northstar Gold Corp.
Prior to going public on the CSE on January 2, 2020, by way of a $3 million Initial Public Offering,
Northstar operated for the past 11 years as a private company focused primarily on gold exploration in
the prolific Kirkland Lake District in northeastern Ontario (>24.5 million ounces gold produced from 7
mines since 1915). During this time, the Company raised nearly $7 million to acquire and advance 3-
100% owned gold and base-metal properties in the Kirkland Lake region.
Northstar has an
accomplished Board, Special Advisor and Management Group comprised of professionals highly
experienced in exploration, mining, finance and investment banking on a global basis.
The Company's flagship property is the 100% owned Miller Gold Property, situated 18 km southeast of
Kirkland Lake and Kirkland Lake Gold's Macassa SMC gold mine. Northstar also has two additional
100%-owned exploration projects in Northern Ontario. The 5,090 hectare Bryce Property is an intrusive-
gold / PME VMS project and the Temagami-Milestone Cu-Ni-Co Property is located in Strathcona
Township.
Northstar intends to advance both projects through joint venture partnerships or otherwise.
On behalf of the Board of Directors,
Mr. Brian P. Fowler, P.Geo.
President, CEO and Director
(604) 617-8191
For further information, please contact:
Derek Wood
Conduit IR
(403) 200-3569
Cautionary Note Regarding Forward-Looking Statements
This news release contains certain forward looking statements which involve known and unknown
risks, delays, and uncertainties not under the control of Northstar Goldcorp. which may cause actual
results, performance or achievements of Northstar Gold Corp to be materially different from the
results, performance or expectation implied by these forward looking statements. By their nature,
forward looking statements involve risk and uncertainties because they relate to events and depend
on factors that will or may occur in the future. Actual results may vary depending upon exploration
activities, industry production, commodity demand and pricing, currency exchange rates, and, but not
limited to, general economic factors.
To view the source version of this press release, please visit
https://www.newsfilecorp.com/release/65549