Liberty Gold Announces First 2019 Drill Results from the Black Pine Oxide Gold Property, Great Basin, USA 1.51 g/t Au over 48.8 metres, 1.45 g/t Au over 45.7 metres and 1.19 g/t Au over 38.1 metres
Page 1 of 4
NEWS RELEASE 19-07 May 29, 2019
Liberty Gold Announces First 2019 Drill Results from the Black Pine Oxide Gold Property,
Great Basin, USA
1.51 g/t Au over 48.8 metres, 1.45 g/t Au over 45.7 metres and 1.19 g/t Au over 38.1 metres
VANCOUVER, B.C. – Liberty Gold Corp. (LGD-TSX) (“Liberty Gold” or the “Company”) is pleased
to announce assay results from the first four reverse circulation (“RC”) holes at its Black Pine
Property in Idaho. The drill holes were designed for infill, validation of historical results, and to
extend historically drilled gold mineralization into a highly prospective, 500-metre-wide gap in
historical drilling. Three of four drill holes hit significant widths of high-grade, oxide gold
mineralization, extending gold mineralization deeper and along strike into the untested section.
Drill hole LBP016 intersected 1.45 grams per tonne gold (“g/t Au”) over 45.7 metres (“m”),
extending mineralization northward into an area with no existing drill holes for 475 m toward the A
Basin target, where Liberty Gold drilling in 2017 intersected 0.58 g/t Au over 39.6 m and 1.10 g/t
Au over 15.2 m and 1.49 g/t Au over 77.8 m of in LBP002 (see January 5, 2018 press release).
Current drilling is now testing the extent of gold mineralization on this section, with results pending.
For a cross section of drill collars and traces for the current release, please click
here: http://libertygold.ca/images/news/2019/may/BlackPineSection_NR05292019.pdf
For a map of drill collars and traces for the current release, please click here:
http://libertygold.ca/images/news/2019/may/BlackPine_NR05292019.pdf
For a complete table of drill results from the current holes, please see below or click
here: http://libertygold.ca/images/news/2019/may/BP_Intercepts05292019.pdf
Key Points:
• Drill holes LBP014 through LBP017 were drilled north of the historic B Pit on a
section between the B Pit and A Basin zone, located approximately 500 m apart.
• Much of the area between the B Pit and A Basin, and east toward the historic A Pit,
has not been tested by drilling. 3D modeling of geology and historic drill holes
suggests that mineralization may extend the full length and width of this corridor at
depth.
• Cyanide-soluble assay results on intervals with >0.20 g/t Au by fire assay show
approximately 87% cyanide solubility across most composite intervals, highlighting
the oxidized nature of mineralization.
• Drill holes LBP014, 015 and 016 are similar to hole LBP002 in that they represent
some of the best unmined intercepts drilled to date on the property, by any operator.
Page 2 of 4
Highlights include:
Hole ID (Az, Dip)
(degrees)
From
(m)
To (m) Intercept
(m)
Au (g/t) Au
Cut-Off
Hole
Length
(m)
Target g/t x m
LBP014 (264, -80) 7.6 15.2 7.6 0.49 0.2 196.6 B Pit 64.9
and 39.6 50.3 10.7 0.27 0.2
and 51.8 89.9 38.1 1.19 0.2
including 62.5 88.4 25.9 1.63 1
and 128.0 150.9 22.9 0.39 0.2
including 128.0 129.5 1.5 1.02 1
and 152.4 158.5 6.1 0.28 0.2
and 184.4 187.5 3.0 0.82 0.2
including 185.9 187.5 1.5 1.36 1
LBP015 (266, -46) 10.7 15.2 4.6 0.36 0.2 196.6 B Pit 82.4
and 67.1 115.8 48.8 1.51 0.2
including 77.7 80.8 3.0 1.31 1
including 91.4 94.5 3.0 6.19 1
and including 91.4 93.0 1.5 10.4 5
including 100.6 106.7 6.1 5.42 1
and including 102.1 105.2 3.0 8.17 5
and 123.4 132.6 9.1 0.32 0.2
and 138.7 144.8 6.1 0.68 0.2
including 140.2 141.7 1.5 1.86 1
LBP016 (306, -46) 12.2 16.8 4.6 0.26 0.2 175.3 B Pit 68.9
and 51.8 56.4 4.6 0.29 0.2
and 89.9 135.6 45.7 1.45 0.2
including 93.0 121.9 29.0 1.99 1
and including 102.1 103.6 1.5 6.9 5
LBP017 (084, -77) 9.1 18.3 9.1 0.34 0.2 166.1 B Pit 25.2
and 25.9 33.5 7.6 0.36 0.2
and 74.7 117.3 42.7 0.45 0.2
including 89.9 91.4 1.5 1.11 1
including 109.7 111.3 1.5 1.82 1
One RC drill was deployed on April 23 to drill an estimated 16,000 m in 80 to 100 holes to provide
a comprehensive test of the core of an oxide gold system estimated at over 12 square kilometres
(“km2”) in size. The drill program represents the culmination of over 2 years of intensive
compilation, modeling and interpretation of the complex geology of the project, as well as a 20
month permitting process. The goal of the 2019 drill program is to carry out a comprehensive test
Page 3 of 4
of the geological and mineralization model over a roughly seven km2 area within the 12 km2
identified gold system, starting with a highly prospective area near the historic A and B pits.
Extensive data compilation, involving over 1800 historic drill holes, thousands of surface soil and
rock samples and 5 shallow pits, suggests that a large volume of rock under and adjacent to zones
of previously drill-tested and/or mined gold mineralization contains highly prospective stratigraphy
and favourable structural settings.
“We have waited a long time for the opportunity to drill and test our model and are thrilled with the
results from the first four holes,” said Cal Everett, CEO of Liberty Gold. “Large, shallow oxide gold
systems are extremely rare in the Great Basin and we believe that Black Pine has multi-million
ounce potential that we can demonstrate by drilling.”
ABOUT BLACK PINE
Black Pine is located in the northern Great Basin, immediately adjacent to the Utah/Idaho border. It
is a Carlin-style gold system, similar in many ways to the prolific deposits located along Nevada’s
Carlin trend. Like Newmont’s Long Canyon deposit, Black Pine represents a growing number of
Carlin-style gold systems located off the main Carlin and Cortez trends in underexplored parts of
the Great Basin. The historic Black Pine Mine operated from 1992 to 1997, during a period of
historically low gold prices, with 435,000 ounces of gold produced from 5 composite, shallow pits,
at an average grade of 0.63 g/t and average recovery of approximately 66%.
A virtual site tour and 3D model of Black Pine is available on the homepage of the Company’s
website: www.libertygold.ca.
Moira Smith, Ph.D., P.Geo., Vice-President Exploration and Geoscience, Liberty Gold, is the Company's designated Qualified Person for this news
release within the meaning of National Instrument 43- 101 Standards of Disclosure for Mineral Projects ("NI 43-101") and has reviewed and validated
that the information contained in the release is accurate. Drill composites were calculated using a cut -off of 0.20 g/t. Drill intersections are reported
as drilled thicknesses. True widths of the mineralized intervals vary between 30 and 100% of the reported lengths due to varying drill hole
orientations,but are typically in the range of 60 to 80% of true width. Drill samples were assayed by ALS Limited in Reno, Nevada for gold by Fire
Assay of a 30 gram (1 assay ton) charge with an AA finish, or if over 5.0 g/t were re -assayed and completed with a gravimetric finish. For these
samples, the gravimetric data were utilized in calculating gold intersections. For any samples assaying over 0.20 ppm an additional cyanide leach
analysis is done where the sample is treated with a 0.25% NaCN solution and rolled for an hour. An aliquot of the final leach solution is then
centrifuged and analyzed by Atomic Absorption Spectroscopy. QA/QC for all drill samples consists of the insertion and continual monitoring of
numerous standards and blanks into the sample stream, and the collection of duplicate samples at random intervals within each batch. Selected
holes are also analyzed for a 51 multi-element geochemical suite by ICP -MS. ALS Geochemistry-Reno is ISO 17025:2005 Accredited, with the Elko
prep lab listed on the scope of accreditation.
ABOUT LIBERTY GOLD
Liberty Gold is focused on exploring the Great Basin of the United States, home to large-scale gold
projects that are ideal for open-pit mining. This region is one of the most prolific gold-producing
regions in the world and stretches across Nevada and into Idaho and Utah. We know the Great
Basin and are driven to discover and advance big gold deposits that can be mined profitably in
open-pit scenarios. Our flagship projects are Goldstrike, Black Pine and Kinsley Mountain, all of
which are past producing open-pit mines, where previous operators only scratched the surface.
For more information, visit www.libertygold.ca or contact:
Susie Bell, Manager, Investor Relations
Phone: 604-632-4677 or Toll Free 1-877-632-4677
Page 4 of 4
All statements in this press release, other than statements of historical fact, are "forward- looking information" with respect to Liberty Gold within the
meaning of applicable securities laws, i ncluding statements that address potential quantity and/or grade of minerals, potential size and expansion of
a mineralized zone, proposed timing of exploration and development plans . Forward-looking information is often, but not always, identified by the
use of words such as "seek", "anticipate", "plan", "continue", "planned", "expect", "project", "predict", "potential", "targeting", "intends", "believe",
"potential", and similar expressions, or describes a "goal", or variation of such words and phrases or state that certain actions, events or results
"may", "should", "could", "would", "might" or "will" be taken, occur or be achieved. Forward -looking information is not a guarantee of future
performance and is based upon a number of estimates and assumptions of management at the date the statements are made including, among
others, assumptions about future prices of gold, and other metal prices, currency exchange rates and interest rates, favourab le operating conditions,
political stability, obtaining governm ental approvals and financing on time, obtaining renewals for existing licens es and permits and obtaining
required licenses and permits, labour stability, stability in market conditions, availability of equipment, accuracy of any mineral resources, the
availability of drill rigs, successful resolution of disputes and anticipated costs and expenditures. Many assumptions are based on factors and events
that are not within the control of Liberty Gold and there is no assurance they will prove to be correct.
Such forward-looking information, involves known and unknown risks, which may cause the actual results to be materially different from any future
results expressed or implied by such forward -looking information, including, risks related to the interpretation of results and/or the reliance on
technical information provided by third parties as related to the Company’s mineral property interests; changes in project pa rameters as plans
continue to be refined; current economic conditions; future prices of commoditi es; possible variations in grade or recovery rates; the costs and
timing of the development of new deposits; failure of equipment or processes to operate as anticipated; the failure of contracted parties to perform;
the timing and success of exploration ac tivities generally; delays in permitting; possible claims against the Company; labour disputes and other risks
of the mining industry; delays in obtaining governmental approvals, financing or in the completion of exploration as well as those factors discus sed
in the Annual Information Form of the Company dated March 2 7, 2019 in the section entitled "Risk Factors", under Liberty Gold’s SEDAR profile
at www.sedar.com.
Although Liberty Gold has attempted to identify important factors that could cause actual actions, events or results to differ materially from those
described in forward-looking information, there may be other factors that cause actions, events or results not to be as anticipated, estimated or
intended. There can be no assurance that such information will prove to be accurate as actual results and future events could differ materially from
those anticipated in such statements. Liberty Gold disclaims any intention or obligation to update or revis e any forward-looking information, whether
as a result of new information, future events or otherwise unless required by law .