Initial Metallurgical Test Work Recovers up to 91% Cu from the Haib Copper Project IN Namibia
Suite 162, 2912 West Broadway, Vancouver, British Columbia, V6K 0E9
Tel : 604-340-0140. E-mail : [email protected]
Web site: http://www.deepsouthresources.com
INITIAL METALLURGICAL TEST WORK RECOVERS UP TO
91% CU FROM THE HAIB COPPER PROJECT IN NAMIBIA
Vancouver, B.C., Canada – July 29, 2019 – Deep-South Resources Inc. ("Deep-
South" or “the Company") (TSX-V: DSM) announces first results from the
metallurgical test work on stockpile material from the Haib Copper Project in
Namibia. The test work program is managed by METS Engineering of Australia and
undertaken by Mintek in South Africa. The program is on schedule and a summary
of the planned program is presented at the end of this press release.
Bio-assisted leach test work results summary:
Two tons of samples are the object of various tests. The samples have been
collected from a stockpile extracted from an adit dug in the higher grade area of the
main Haib deposit. The samples have not been weathered and are considered
representative of the sulphide mineralized material at Haib.
The Haib head assay revealed 0.73% Copper, 3.7% sulfur with minor elements and
the balance 28.4% Silica. There are no deleterious elements. The mineralogy of
the milled Haib feed revealed over 98.5% Chalcopyrite, 1% Bornite, and less than
0.5% of Chalcocite, Covellite, Malachite and Chrysocolla.
The acid consumption was measured across a number of tests. The net average
acid consumption was between 10.3 and 11.6 kg/tonne which is an excellent low
benchmark number. Acid is usually a major cost with leaching. However, the Haib
mineralized material contains pyrite which generates acid during leaching and
contributes to the lower consumption.
High Pressure Grinding Roll (HPGR) optimisation tests demonstrated that the hard
Haib mineralized material is amenable to HPGR. A 60 bar is deemed to be the
ideal pressure as the particle size distribution was not reduced once the pressure
exceeded this value.
Agitated tanks bacterial leaching of P80 75 micron thick grounded mineralized
material achieved between 91% copper recovery in one tank and 86% in the other
tank in 46 days. The results demonstrate that high recoveries of copper can be
achieved on the Haib mineralized material with bio-assisted leaching. (see agitated
bacterial leaching tanks figures below)
Assays of the residue will be taken at the end of the program and will serve to
confirm the final recoveries rates.
Mr. John Akwenye, Chairman of Deep-South stated that: “In general,
chalcopyrite is hard to leach. However, with the com bination of HPGR
optimization, agglomeration and t he right bacteria mix to support the
leaching, the results are highly promising”.
The mineralized material agglomerated without any issues. Heap leaching relies on the
ability of the leaching solution to penetrate through the mound, around the mineralized
material particles. When the mineralized material is not agglomerated, fine particles may
vary in size and shape, reducing the ability of the solution to penetrate through the heap,
as smaller fines clog the spaces between larger fines. Using an agglomeration drum to
agglomerate the mineralized material fine particles will ensure crushed mineralized
material particles are more uniform, making it easier for the leaching solution to travel
through the channels between particles to help maximize recovery.
Six - 1 metre columns have been initiated at Mintek on -4.7mm, -3.35mm and
-2.36mm mineralized material and the copper leaching recovery is progressing ahead of
plan. It is important to note that the expected leaching time period in columns will be
longer than in agitated tanks.
Mineralized material sorting tests will be conducted in Perth, Australia next week to
evaluate if the Haib mineralized material is amenable to beneficiation by mineralized
material sorting.
Further results will be disclosed during the course of the test work scheduled to continue
until December 2019.
Qualified Person
Damian E.G. Connelly, BSc (Applied Science), FAusIMM, CP (Met), Director of Mineral
Engineering Technical Services is responsible for the technical part of this press release
and is the designated Qualified Person under the terms of National Instrument 43-101.
Summary of the planned program:
The bulk head sample will be crushed down to -12.5 mm with a jaw crusher.
The jaw crusher product will then be sub-sampled, and crushed with an HPGR to -5 mm,
-3.35 mm and -2 mm, respectively. Sub-samples from each crush size will be removed
for curing acid optimization tests, assay-by-size (4 size classes), geo-mechanical tests
and column leach tests. Additional head sample will be milled to 80% passing 75 µm for
chemical head assay by ICP-OES, sequential Cu (acid-soluble, cyanide-soluble and
residual copper). Acid consumption (iso-pH) tests and batch stirred tank amenability
tests will be performed on the head sample. Mineralogy (XRD and SEM) will be
performed on the -2 mm head sample. The column leaching test will be carried out at a
temperature of 60 °C for a total duration of 200 days. However, interim results will be
available on a regular basis.
About Mintek:
Mintek is South Africa’s national mineral research organisation established in 1934
to assist in ensuring sustainable growth in the minerals and metal industries through
research, development & innovation (RDI). The organisation has grown over the years
into an internationally competitive, respected research and development centre of
metallurgical and mineral processing technologies. Mintek’s Biotechnology Division has
been involved in the development of tank and heap bioleaching technologies for over 30
years. Mintek also specialises in hydrometallurgy, including leaching, precipitation,
solvent extraction and electrowinning. You can visit Mintek at : https://www.mintek.co.za
About METS :
Established in 1988, Mineral Engineering Technical Services provides a range of
services in the fields of Minerals Processing, Hydrometallurgy and Pyrometallurgy.
METS is the engineering company that produced Deep-South’s Preliminary Economic
Assessment (PEA) disclosed on February 26, 2018. You can visit METS at :
https://www.metsengineering.com
About Deep-South Resources Inc.
Deep-South Resources Inc. is a mineral exploration company largely held by
Namibian shareholders and Management with 25% and Teck Resources Ltd with
28% of Deep-South share capital. Deep-South currently holds 100% of the Haib
Copper project in Namibia, one of the largest copper porphyry deposits in Africa.
Deep-South’s growth strategy is to focus on the exploration and development of
quality assets, in significant mineralized zones, close to infrastructure, in stable
countries.
This press release contains certain "forward-looking statements," as identified in Deep - South’s
periodic filings with Canadian Securities Regulators that involve a number of risks and uncertainties.
There can be no assurance that such statements will prove to be accurate and actual results and future
events could differ materially from those anticipated in such statements.Neither the TSX Venture
Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX
Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.
More information is available by contacting Pierre Léveillé, President & CEO at
+1-819-340-0140 or at: [email protected] or
Paradox Public Relations at +1-514-341-0408.