iMetal Resources Commences Trenching at Gowganda West
iMetal Resources Commences Trenching at Gowganda West
VANCOUVER, BC / ACCESSWIRE / July 9, 2021 / iMetal Resources, Inc. (TSX.V:IMR)
(OTC PINK:ADTFF) (FRANKFURT:A7V2) ('iMetal' or the 'Company') is pleased to
announce the commencement of trenching at its flagship Gowganda West property in the
Shining Tree District of the Abitibi Greenstone Gold Belt of Northern Ontario. The two-week
program will concentrate on Zone 1 and Zone 3, where results from the April 2021 sampling
program returned highlight gold grab sample values of:
• Zone 3 returned: 11.3 g/t, 29.6 g/t and 67.9 g/t gold;
• Zone 1 returned: 27.2 and 16.35 g/t gold;
• A value of 3.72 g/t gold was returned from a location approximately 400 metres NW of
Zone 1
iMetal cautions investors the grab samples are selective and may not necessarily be
representative of the showing as a whole.
'We have been anxious to get the mechanical trenching program underway at the key target areas
of the Gowganda West property, to define targets for drilling in the upcoming late summer drill
program,' commented iMetal President & CEO Saf Dhillon. 'The trenching will open up Zone 1
and Zone 3 exposing the structures along strike and allow field crews to better evaluate the test
IP anomalies identified during the recent reprocessing and interpretation of the 2019 IP results,
as well as test the newly discovered Zone 400 metres to the NW of Zone 1,' he concluded.
Zone 1 is associated with Timiskaming type metasedimentary rocks comprising siltstone,
sandstone and predominately conglomerate. Gold mineralization is found where conglomerate
transitions into finer grained rock types. The conglomerate contains clasts of jasper rich, banded
iron formation and is highly magnetic. In addition, the conglomerate contains significant
amounts of pyrite, resulting in the unit showing as strongly conductive in induced polarization
surveys. The 2018 airborne mag and 2019 IP surveys have allowed mapping of the conglomerate
and its boundaries. The boundaries will be the focus of trenching programs.
Figure1. Zone 1 Sampling
Trenching will include stripping older exposures cleared in recent decades where the bedrock
shows potassic alteration and silica flooding. Trenching will expose this area over a 50m length
whereby field crews can use diamond blade saws to take continuous samples over the entire
mineralized width enabling geologists to evaluate the extend of the mineralized system and
establish the best drill targets. Presently the company believes gold mineralization is associated
with narrow, quartz-carbonate-pyrite veins hosted within wider zones of ankerite-albite-silica-
sericite alteration and variable amounts of fine-grained, disseminated pyrite. The work now
underway should provide more geological context and better information on the nature and
orientation of the mineralization.
Figure1. Zone 3 Sampling
Zone 3 similarly is hosted in metasedimentary rocks; however, the mineralization is oriented
northeast-southwest and dips westward. iMetal has planned 3 trenches over a 200m strike
distance to look at the continuity and test the grades in this area. Recent sampling returned stellar
grades up to 67 g/t gold in this area. Trenching would hopefully show these grades to extend
northeastward.
The table below shows the best results from the spring sampling and prospecting program
originallypresented in a press release dated May 11th, 2021.
Table 1. Grab Samples from 2021 prospecting work in Excess of 0.1 g/t Gold
Sample ID g/t gold Location Sample ID g/t gold Location
167303 67.9 Zone 3 167397 27.2 Zone 1
167252 29.6 Zone 3 167398 16.35 Zone 1
167015 11.3 Zone 3 167003 2.11 Zone 1
167008 4.02 Zone 3
167009 2.27 Zone 3 167312 3.76 Zone 1 W
Quality Assurance and Quality Control
All grab samples were delivered by the geological contractor to ALS Minerals in Thunder Bay,
an ISO/IEC 17025:2017 accredited facility. All samples were analyzed with ALS's AuME-TL43
procedure, a 25 gram aqua regia digestion with an ICP-MS finish with a 1 gram upper limit for
gold. All overlimit gold values were fire assayed with a 30-gram sample and a gravimetric finish,
ALS's Au-GRA21 procedure.
About Gowganda West
The Gowganda West property covers approximately 147 sq km in the Shining Tree volcano-
sedimentary succession of the southwestern Abitibi Greenstone Gold Belt contiguous to the
north and west of Aris Gold Corp.'s (TSX: ARIS) (formerly Caldas Gold Corp.) Juby Gold
deposit, a series of four mineralized alteration zones along the Tyrrell Shear Zone. Gold
mineralization at Juby is associated with narrow quartz-carbonate-pyrite veins hosted within 20-
to 330-metre-wide zones of ankerite-albite-silica-sericite alteration and variable amounts of fine-
grained, disseminated pyrite and also with multiple lenses containing narrow (<5m), higher grade
quartz-carbonate-pyrite veins hosted within 5 to 50 metre zones of ankerite-albite-silica-sericite
alteration and variable amounts of fine-grained, disseminated pyrite. The Juby Deposits host
indicated resources of 774,000 ounces at 1.13 g/t Au and inferred resources of 1,488,000 ounces
at 0.98 g/t Au. iMetal cautions investors mineralization at Juby is not necessarily indicative of
similar mineralization at Gowganda West. Source: Technical Report on the Updated Mineral
Resource Estimate for the Juby Gold Deposit for Caldas Gold Corp. (named currently changed
to Aris Gold Corp.) Dated 2020-Oct-05 By: J. Campbell, A. Sexton, D. Studd, and A. Armitage.
iMetal acquired Gowganda West in 2016, discovering Zone 1 and Zone 3 through focused
exploration proximal to the Aris property border, and subsequently completing programs of
prospecting, channel sampling, airborne VTEM, ground IP and limited diamond drilling.
Zone 1 has excellent access and has been traced over 500m south from the Juby property
boundary. Two distinct outcrop areas approximately 300m apart have been sampled, Zone 1 and
Zone 1 South. Selective grab samples returned: 6.47 g/t Au from Zone 1 and 39.3 g/t Au, and
16.9 g/t Au from Zone 1 South. Five holes were subsequently drilled in 2019 and one in 2020 at
Zone 1, focusing on a short 150 strike length of Zone 1 South. The best drill intersections
included: 2.95 g/t Au over 2.5 metres, 1.43 g/t Au over 4.6 metres and longer intervals of 0.37 g/t
au over 29.4 metres and 0.32 g/t au over 30.25 metres.
Zone 3 consists of two distinct areas separated by 225 metres, 3A and 3B are located
approximately 6 kilometres due south of Zone 1, Highlights from Zone 3A grab sample results
include 56.59 g/t Au and 34.81 g/t Au, while highlight Zone 3B grab sample results include
14.74 g/t Au and 12.7 g/t Au. Zone 3A and Zone 3B remain undrilled.
About iMetal Resources Inc.
A Canadian based junior exploration company focused on the exploration and development of its
portfolio of resource properties in Ontario and Quebec. iMetal is focused on advancing its
Gowganda West Project that borders the Juby Project, an advanced exploration-stage gold
project located within the Shining Tree area in the southern part of the Abitibi greenstone belt
about 100 km south-southeast of the Timmins gold camp.
The Company is also focused on the Oakes Gold Project which forms part of a portfolio of
projects it recently acquired from Riverside Resources Inc. (TSXV: RRI) who is now a strategic
investor/partner. The Oakes Gold Project is located in the Oakes Township just north of
Canadian National Highway 11 and about 2km north of the town of Long Lac, Ontario. The
Oakes Township is part of the well-endowed Beardmore-Geraldton Greenstone Belt region,
located northeast of Thunder Bay, Ontario and the region has a long and rich mining history that
has produced 4.1 million ounces of gold over the past 100 years including the combined
MacLeod-Cockshutt Mine, which produced 1.5 million ounces of gold. More recently, the
Hardrock Project held 50% by Equinox Gold Corp. (TSX: EQX) has elevated attention to the
area by announcing their intention to mine their gold resource near Geraldton, Ontario.
Qualified Person
The scientific and technical information contained in this news release has been reviewed and
approved by R. Tim Henneberry, PGeo (British Columbia), a Director of iMetal, and a 'qualified
person' as defined in National Instrument 43-101.
ON BEHALF OF THE BOARD OF DIRECTORS,
Saf Dhillon
President & CEO
iMetal Resources Inc.
Tel. (604-484-3031)
Suite 510, 580 Hornby Street, Vancouver, British Columbia, V6C 3B6.
https://imetalresources.ca
Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined
in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy
of this release.
This news release may include forward-looking statements that are subject to risks and
uncertainties. All statements within, other than statements of historical fact, are to be considered
forward looking. Forward-looking statements in this news release include, but are not limited to:
statements with respect to future exploration and drilling of the Company; statements with
respect to the release of assays and exploration results; and statements with respect to the
Company's geological understanding of its mineral properties. Although the Company believes
the expectations expressed in such forward-looking statements are based on reasonable
assumptions, such statements are not guarantees of future performance and actual results or
developments may differ materially from those in forward-looking statements. Factors that could
cause actual results to differ materially from those in forward-looking statements include results
of exploration, variations in results of mineralization, relationships with local communities,
market prices, continued availability of capital and financing, and general economic, market or
business conditions. There can be no assurances that such statements will prove accurate and,
therefore, readers are advised to rely on their own evaluation of such uncertainties. We do not
assume any obligation to update any forward-looking statements except as required under the
applicable laws.
SOURCE: iMetal Resources, Inc.