EV Nickel Phase 3 Drilling Results: Continued Success Outlining Large-Scale CarLang Nickel Zone
EV Nickel Phase 3 Drilling Results: Continued Success Outlining
Large-Scale CarLang Nickel Zone
NOT FOR DISSEMINATION IN THE UNITED STATES OF AMERICA OR TO US
WIRE SERVICES
• Reports assay results from 4 additional holes, Intersections included:
o hole EV22-22 with 141.50m grading 0.26% Ni, and
o hole EV22-24 with 223.90m grading 0.25% Ni.
• The CarLang Area is a >10km prospective trend of dunitic units.
• 1.4km of the prospective strike was drilled this summer, with 28 holes totalling 8,295m
.
• Analytical results are pending for the remaining 20 holes and will be utilized in a
CarLang A Zone Preliminary Resource, planned for Q1 2023.
TORONTO, ON / ACCESSWIRE / November 27, 2022 / EV NICKEL INC. (TSX-V:EVNI)
("EVNi" or the "Company") is excited to announce the additional assay results, from 4 more holes
of the Phase 3 Drilling program targeting the Large-Scale nickel target in the northeast of its Shaw
Dome Project, referred to as the Carman -Langmuir or, "CarLang Area". These assays continue
to confirm the new "CarLang A Zone" as a potential Large-Scale nickel prospect (for prior results,
see news release dated October 24, 2022).
"The new Large-Scale CarLang A Zone continues to return the anticipated results, confirming the
enormous potential of the area. The Company has only focused on the first ~15% of strike of the
dunitic body to verify the interpreted zone." said Sean Samson, President & CEO "Expanding the
expression of the zone would be as easy as continuing to drill along the trends of the dunites that
extend for an additional 8 km within the CarLang Area- where surface sampling has indicated the
presence of similar dunites. 2023 will be very exciting for EV Nickel, with the remaining Phase 3
assay results and then the CarLang A Zone preliminary resource and W4 Zone updated resource
both planned for the first half of the year."
Based upon airborne geophysical surveys and known surface exposures of dunitic outcrops, the
CarLang Area is interpreted to host >10km of prospective strike length of prospective dunite (see
Figure 2), and the completed Phase 3 drilling identified the CarLang A Zone, covering 1.4km of
the interpreted strike length, or ~15% of the total potential. The dunitic body forming the CarLang
A Zone has interpreted widths that range from approximately 400 metres to greater than 500 metres
based upon the Phase 3 diamond drill program, airborne geophysical surveys and surface outcrop
exposures.
With Phase 3, EVNi completed 28 holes representing 8,295m of diamond drill core across the
CarLang A Zone The drilling was focused in an area where eight EVNi Surface Samples were
taken earlier this year, which averaged 0.26% Ni (wt%). The Company had decided to test the
CarLang A Zone to a vertical depth of 250 metres. EVNi interprets that the host dunites extend
below the current drill depth as indicated by multiple holes bottoming in the dunitic body including
5 of the 8 holes that have been press released with the other 3 holes having been completed along
the footwall boundary and designed to penetrate fully through the dunites.
"Historic drilling in the CarLang Area has identified t hat the host dunitic bodies extend beyond
450 metres in vertical depth." said Paul Davis, Vice President Exploration, "However, having the
benefit of outcrop exposures and well-defined geophysical boundaries, exploring along the trend
is beneficial in term s of exploration spending, timing and mineralized zone expansion potential.
We have only started to scratch the surface regarding the potential of the CarLang Area and the
overall dimensions of this Large-Scale Zone."
Assay results continue to intersect thick sequences of dunite hosting large -scale, broad zones of
nickel mineralization. The Phase 3 drill program confirms the continuity of the dunitic body along
the full strike length of the CarLang A Zone, consistent with the Company's original interpretation
of the area. Assays are pending on the remaining 20 holes and are expected to be received through
the coming weeks and all analyses are scheduled to be completed by the end of Jan uary 2023.
Work on the Preliminary Resource Estimate for the CarLang A Zone will begin in the coming
weeks and results are anticipated in first quarter of 2023.
Favourable Project Characteristics
The CarLang Area has many favourable characteristics including: easy accessibility by road with
significant outcrop exposure of the dunitic rocks across the prop erty; recent logging activity has
exposed additional outcrop and developed a network of gravel access roads; and the interpreted
thickness of the overburden covering the CarLang A Zone is estimated to average of less than 5
meters based upon the recent Pha se 3 drill hole program, with a significant portion sub -cropping
to surface with less than 1 metre of overburden.
When these factors are combined, the Company believes that the CarLang Area is better positioned
for any future development and will rise to t he top of the areas of interest for large -scale nickel
projects.
Carbon Capture and Sequestration
The Company has completed a preliminary examination of the minerals contained within surface
samples of the dunitic rocks exposed in the Carlang Area. These s urface samples have been
completely altered to serpentine with varying amounts of brucite and talc which have been
identified as key minerals capable of reacting with CO2 to form stable minerals locking the carbon
and removing it from the atmosphere (Cutts, J. A., Steinthorsdottir, K., Turvey, C., Dipple, G. M.,
Enkin, R. J., & Peacock, S. M. (2021), ‘Deducing mineralogy of serpentinized and carbonated
ultramafic rocks using physical properties with implications for carbon sequestration and
subduction zone dynamics.' Geochemistry, Geophysics, Geosystems , Volume 22, Issue 9
e2021GC009989. https://doi.org/10.1029/2021GC009989).
The Company is considering a number of options to quantify the carbon capture potential of the
CarLang host rocks, as part of EV Nickel's Clean Nickel TM strategy (for further detail see News
Release dated May 2, 2022).
Assay QA/QC
Drill core samples from EVNi drilling at the Shaw Dome Project are cut or whole core sampled
and bagged at the core logging facility located near the Shaw Dome Project and transported to
ALS Canada Ltd. ("ALS") and SGS Canada Inc. ("SGS") for analysis. Sam ples, along with
certified standards and blanks, that are included by the Company for quality assurance and quality
control, were prepared and analyzed at the laboratories . At ALS, samples are crushed to 70% less
than 2mm. A riffle split is pulverized to 85% passing 75 microns. Nickel, copper, cobalt and
sulphur are analyzed by sodium peroxide fusion with an ICP finish and platinum, palladium and
gold by fire assay and ICP -AES finish. At SGS, samples are crushed to 75% less than 2mm. A
riffle split is pulv erized to 85% passing 75 microns. Nickel, copper and cobalt are analyzed by
sodium peroxide fusion with an ICP -AES finish, platinum, palladium and gold by fire assay and
ICP-AES finish and sulphur by Leco. These and future assay results may vary from time to time
due to re‒analysis for quality assurance and quality control.
About EV Nickel Inc.
EV Nickel's mission is to accelerate the transition to clean energy. It is a Canadian nickel
exploration company, focussed on the Shaw Dome Project, south of Timmins, Ontario. The Shaw
Dome includes the W4 Zone, the basis of a 2010 historical estimate of 677K tonnes @ 1.00% Ni,
~15M lbs of Class 1 Nickel. EV Nickel plans to grow and advance a nickel business, targeting the
growing demand for Class 1 Nickel, from the e lectric vehicle battery sector. EV Nickel has over
30,000 hectares to explore across the Shaw Dome and has identified >100 km of additional
favourable strike length. The Company is focused on a 2-track strategy with High-Grade (starting
with W4) and Large-Scale targets (starting with CarLang).
Qualified Person
The Company's Projects are under the direct technical supervision of Paul Davis, P.Geo., and Vice-
President of the Company. Mr. Davis is a Qualified Person as defined by NI 43 -101. He has
reviewed and approved the technical information in this press release. There are no known factors
that could materially affect the reliability of the information verified by Mr. Davis.
Cautionary Note Regarding Forward-Looking Statements:
This press release contains f orward-looking information. Such forward -looking statements or
information are provided for the purpose of providing information about management's current
expectations and plans relating to the future. Readers are cautioned that reliance on such
information may not be appropriate for other purposes. Any such forward -looking information
may be identified by words such as "anticipate", "proposed", "estimates", "would", "expects",
"intends", "plans", "may", "will", and similar expressions. Forward -looking sta tements or
information are based on a number of factors and assumptions which have been used to develop
such statements and information, but which may prove to be incorrect. Although EV Nickel
believes that the expectations reflected in such forward -looking statements or information are
reasonable, undue reliance should not be placed on forward -looking statements because the
Company can give no assurance that such expectations will prove to be correct. Factors that could
cause actual results to differ materially from those described in such forward-looking information
include, but are not limited to, changes in business plans and strategies, market conditions, share
price, best use of available cash, the ability of the Company to raise sufficient capital to fund its
obligations under various contractual arrangements, to maintain its mineral tenures and
concessions in good standing, and to explore and develop its projects and for general working
capital purposes, changes in economic conditions or financial mar kets, the inherent hazards
associated with mineral exploration, future prices of metals and other commodities, environmental
challenges and risks, the Company's ability to obtain the necessary permits and consents required
to explore, drill and develop its projects and if obtained, to obtain such permits and consents in a
timely fashion relative to the Company's plans and business objectives, changes in environmental
and other laws or regulations that could have an impact on the Company's operations, compliance
with such laws and regulations, the Company's ability to obtain required shareholder or regulatory
approvals, dependence on key management personnel, natural disasters and global pandemics,
including COVID -19 and general competition in the mining indu stry. These risks, as well as
others, could cause actual results and events to vary significantly. The forward -looking
information in this press release reflects the current expectations, assumptions and/or beliefs of
EV Nickel based on information current ly available to the Company. Any forward -looking
information speaks only as of the date on which it is made and, except as may be required by
applicable securities laws, the Company disclaims any intent or obligation to update any forward-
looking information, whether as a result of new information, future events or results or expressly
qualified by this cautionary statement.
Contact Information