AZS.V · 2026-08-13 13:00:00

Arizona Gold & Silver Intersects 21.79 Metres grading 4.10 g/t Gold at Philadelphia

Drill Results

Deeper Drilling Beneath High-Grade Perry Zone Now Underway

Vancouver, British Columbia - TheNewswire - August 13, 2026 – Arizona Gold & Silver Inc. ("Arizona" or the "Company") (TSXV: AZS) (OTCQB: AZASF) is pleased to report assay results from four diamond drill holes completed at its Philadelphia Project in Arizona. The results extend both high-grade and broad zones of gold mineralization approximately 150 metres vertically above previously reported high-grade intersections in the Perry Zone. Today’s results further demonstrate the expanding size and large scale of the gold-silver hydrothermal system along Arabian Fault system with enhanced fluid flow and mineralization development in the Perry Zone area.

With expanded U.S. Bureau of Land Management ("BLM") permits now in place, drilling has transitioned to testing the projected down-dip continuation of the high-grade intercepts in the Perry Zone beneath the hematite and argillic altered cap to the Red Hills (Figure 1).

Highlights

PC26-169: 21.79 metres grading 4.10 g/t gold and 5.8 g/t silver, within 73.46 metres grading 1.69 g/t gold and 4.4 g/t silver.

PC26-167: 15.24 metres grading 2.66 g/t gold and 5.6 g/t silver, within 66.81 metres grading 1.12 g/t gold and 4.0 g/t silver.

The four holes released today (see Table 1 below) demonstrate a broad gold mineralized zone extending approximately 150 metres vertically above the previously reported high-grade Perry Zone intersections.

The recently received expanded BLM permit provides access to 16 additional drill pads, enabling systematic testing of the Perry Zone at depth and multiple high-priority targets across the Philadelphia Project with this deeper phase of drilling underway and expected to continue through 2026.

Dr. Lex Lambeck, Senior Vice President Exploration, commented:

“These results further strengthen our geological model, demonstrating broad gold mineralization within the Perry Zone and increasing our confidence in the geometry and continuity of the system"

“Importantly drilling has now moved below these higher-grade intersections with drilling underway testing the projected down-dip continuation of the Perry Zone together with a CSAMT geophysical target beneath Red Hills. This represents an important next step expanding the high-grade core of the Perry Zone, further proofing our geological model and testing an exciting target beneath the strong alteration seen at surface in the Red Hills" (Figure 1).

Drill Results

The four holes reported in this release: PC26-165, PC26-166, PC26-167 and PC26-169: were designed primarily to test up-dip extensions of mineralization previously intersected in the Perry Zone and further define the broader mineralized envelope above the which occurs around the high-grade core of the system.

PC26-169

Hole PC26-169 was drilled approximately 30 metres north of PC25-154 (22.47m at 3.05 Au gpt) at an azimuth of 330 degrees and an inclination of -80 degrees. The hole tested the up-dip extension of mineralization encountered in PC25-157 (6.28m at 7.02 Au gpt) and intersected mineralized rhyolite and andesite quartz breccia and calcite breccia.

Significant results include:

21.79 metres at 4.10 g/t Au and 5.8 g/t Ag
within 37.34 metres at 3.10 g/t Au and 7.1 g/t Ag
within 73.46 metres at 1.69 g/t Au and 4.4 g/t Ag

Mineralization is associated with strong andesite-hosted quartz-calcite veining and brecciation and occurs above the interpreted boiling horizon within the upper portion of the hydrothermal system.

PC26-165

Hole PC26-165 was drilled approximately 90 metres above PC23-111 at an azimuth of 213 degrees and an inclination of -79 degrees. The hole tested the up-dip continuation of mineralization and intersected a broad mineralized corridor hosted by quartz-rich rhyolite breccia and calcite breccia.

Significant results include:

0.98 metres at 10.19 g/t Au and 8.7 g/t Ag
within 3.11 metres at 3.34 g/t Au and 12.7 g/t Ag
6.95 metres at 2.07 g/t Au and 2.9 g/t Ag
within 62.27 metres at 0.70 g/t Au and 2.0 g/t Ag

Mineralization occurs stratigraphically above the interpreted boiling horizon and is characterized by quartz-rich brecciation and progressively stronger calcite veining with depth.

PC26-167

Hole PC26-167 drilled approximately 90 metres above PC25-156 (20.43m at 9.04 gpt Au) at an azimuth of 319 degrees and an inclination of -75 degrees. The hole tested the up-dip continuation of the Perry Zone and intersected a broad zone of mineralization within the upper portion of the interpreted hydrothermal upwelling system.

Significant results include:

15.24 metres at 2.66 g/t Au and 5.6 g/t Ag
within 28.35 metres at 2.19 g/t Au and 7.9 g/t Ag
within 66.81 metres at 1.12 g/t Au and 4.0 g/t Ag

Alteration, brecciation and vein textures are consistent with drilling remaining within the upper portion of the hydrothermal system above the high-grade portion of the Perry Zone.

PC26-166

Hole PC26-166 was drilled approximately 20 metres below PC25-154 (22.47m at 3.05 gpt Au) at an azimuth of 305 degrees and an inclination of -75 degrees. The hole tested the up-dip continuation of the Perry Zone and intersected broad gold mineralization within the upper hydrothermal system.

Significant results include:

1.37 metres at 3.02 g/t Au and 6.6 g/t Ag
within 23.64 metres at 1.42 g/t Au and 6.8 g/t Ag
within 32.95 metres at 1.11 g/t Au and 6.0 g/t Ag

Table 1: Key grade/thickness intervals

Drill hole	Cut off (g)	From (m)	To (m)	Thick (m)	Au gpt	Ag gpt
PC26-169	3	256.18	277.97	21.79	4.1	5.8
within	1	245.36	282.70	37.34	3.1	7.1
within	0.25	242.41	284.38	73.46	1.69	4.4

PC26-165	3	142.19	143.16	0.98	10.19	8.7
within	1	110.83	113.93	3.11	3.34	12.7
	1	142.19	149.14	6.95	2.07	2.9
within	0.25	109.42	171.69	62.27	0.70	2.0

PC26-167	3	229.21	244.45	15.24	2.66	5.6
within	1	226.77	255.12	28.35	2.19	7.9
within	0.25	191.11	257.92	66.81	1.12	4.0

PC26-166	3	247.35	248.72	1.37	3.02	6.6
within	1	234.62	258.32	23.64	1.42	6.8
within	0.25	227.69	260.63	32.95	1.11	6.0

True thickness of the above intercepts is estimated at 60% of drilled thickness.
In calculating average grade of the reported intercepts, the sequence starts and ends at the cutoff grades assigned by the Company (outlined in Table 1).

Next Phase of Exploration: Testing the Perry Zone at Depth

The drilling reported in this release has defined an additional 150+ metres of vertically continuous gold mineralization above the high-grade intercepts previously reported in the deepest Perry Zone intercepts, further defining a broad mineralized envelope and strengthening the Company's geological model.

With expanded BLM permitting now in place, drilling has moved to the projected down-dip continuation of the Perry Zone beneath Red Hills (Figure 1). Deeper drilling will test both the Perry Zone and a coincident Controlled-Source Audio-frequency Magnetotellurics ("CSAMT") geophysical anomaly. Widespread hematite alteration and abundant pseudomorphs after pyrite at Red Hills support the interpretation that the area represents the upper expression of a large hydrothermal system which includes the east-dipping Perry Zone.

The expanded permit provides access to 16 additional drill pads and the flexibility to operate multiple rigs, enabling systematic testing of the Perry Zone at depth and other high-priority targets. Exploration is also advancing over the Eastern and Northeastern hyperspectral anomalies as the Company evaluates the district-scale potential of the Philadelphia low-sulfidation epithermal gold system.

Figure 1: Red Hills Boiling Zone Beneath Rhyolite Flow Dome looking northeast. The surface argillic alteration is approximately 650m wide.

Click Image To View Full Size

QA/QC Protocols

All core samples were processed at Skyline Labs in Tucson, Arizona, International Standard ISO 9001:2015. Gold was analyzed by fire assay with AA finish, with over-limits re-analyzed gravimetrically. Silver and multi-element analysis were completed using ICP-MS methods. The Company maintains a rigorous QA/QC program including insertion of certified standards and blanks.

Qualified Person

Dr. Lex Lambeck, SVP Exploration for Arizona Gold and Silver and Certified Professional Geologist (11734), is the Qualified Person under NI 43-101 for this release and has reviewed the drill core and assay data for this release and approved the technical content of this release.

About Arizona Gold & Silver Inc.

Arizona Gold & Silver Inc. is a leading exploration company focused on uncovering precious metal resources in Arizona and Nevada. With a commitment to sustainable practices and innovative exploration techniques, the company aims to drive value for stakeholders while prioritizing environmental stewardship. The flagship asset is the Philadelphia gold-silver property where the Company is drilling off an large scale epithermal gold-silver system.

On behalf of the Board of Directors:

ARIZONA GOLD & SILVER INC.

Mike Stark, President and CEO, Director
Phone: (604) 833-4278

Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.

CAUTION CONCERNING FORWARD-LOOKING STATEMENTS

This news release includes certain forward-looking statements or information. All statements other than statements of historical fact included in this release are forward-looking statements that involve various risks and uncertainties. Forward-looking statements in this news release include statements in relation to the timing, cost and other aspects of the 2026 exploration program; the potential for development of the mineral resources; the potential mineralization and geological merits of the exploration properties; and other future plans, objectives or expectations of the Company. There can be no assurance that such statements will prove to be accurate and actual results and future events could differ materially from those anticipated in such statements. Important factors that could cause actual results to differ materially from the Company’s plans or expectations include the risk that actual results of current and planned exploration activities, including the results of the Company’s 2026 drilling program(s) on its properties, will not be consistent with the Company’s expectations; the geology, grade and continuity of any mineral deposits and the risk of unexpected variations in mineral resources, grade and/or recovery rates; fluctuating metals prices; possibility of accidents, equipment breakdowns and delays during exploration; exploration cost overruns or unanticipated costs and expenses; uncertainties involved in the interpretation of drilling results and geological tests; availability of capital and financing required to continue the Company’s future exploration programs and preparation of geological reports and studies; delays in the preparation of geological reports and studies; the metallurgical characteristics of mineralization contained within the exploration properties are yet to be fully determined; general economic, market or business conditions; competition and loss of key employees; regulatory changes and restrictions including in relation to required permits for exploration activities (including drilling permits) and environmental liability; timeliness of government or regulatory approvals; and other risks detailed herein and from time to time in the filings made by the Company with securities regulators. In connection with the forward-looking information contained in this news release, the Company has made numerous assumptions, including that the Company’s 2026 programs would proceed as planned and within budget. The Company expressly disclaims any intention or obligation to update or revise any forward-looking statements whether as a result of new information, future events or otherwise, except as otherwise required by applicable securities legislation.

← Back to feed