Sunday, September 20, 2026
MiningNewsTerminal
Sunday, September 20, 2026 Admin

LTHM.CN ·

Champion Electric Reports Lithium Discovery from the Initial Field Program at Its James Bay Lithium Properties in Eeyou Istchee, Quebec

Exploration Programs

Champion Electric Reports Lithium Discovery

from the Initial Field Program at Its James Bay

Lithium Properties in Eeyou Istchee, Quebec

Toronto, Ontario--(Newsfile Corp. - December 18, 2023) -

Champion Electric Metals Inc.

(CSE: LTHM)

(OTCQB: CHELF) (FSE: 1QB0) ("

Champion Electric

" or the "

Company

") is delighted to announce

that the Company has made a spodumene discovery from rock and till sampling at its James Bay lithium

properties (the "

Property

"). Spodumene is the primary ore mineral in lithium pegmatite deposits.

The

ongoing exploration program, which began in spring 2023

, included close to 700 rock samples and

well over 300 till samples which were collected late this summer and fall 2023 (Figure 1).

Current Highlights of 2023 Sampling Program:

Angular spodumene boulders recovered from sample pit at the new Western prospect

(Figure 2)

Till sample from the same site yielded >1,500 grains of spodumene (Figure 3)

No significant outcrop in the area or immediately up-ice

Three large fractionation trends identified from rock geochemistry (Figure 3)

Western trend is in the vicinity of the Western prospect

Anomalous lithium rock samples occur in clusters that are more than 15 km

and 40 km east of the Western prospect (Figure 1)

"The discovery of the angular spodumene boulder and delicate spodumene crystals in till samples

presents evidence that a spodumene bearing pegmatite system exists nearby and within a few

kilometres of Patriot's Corvette deposit. We anticipate the remaining till sample results shortly and will

focus our exploration planning on vectoring back to the source of the transported spodumene,"

commented

Jonathan Buick, President & CEO.

"

Our James Bay lithium properties are mostly

covered by glacial and alluvial deposits. For this reason, we strategically split the surface sampling

program between outcrop rock sampling and till sampling for the target areas beneath the cover. All

this new data and the addition of geophysics planned for this winter will make our 2024 program very

exciting."

The outcrop sampling and mapping concentrated in areas of reported potential pegmatite occurrences.

Some of the rock samples contained highly anomalous lithium (Li), cesium (Cs), tantalum (Ta), and

beryllium (Be), but significant outcropping spodumene has yet to be encountered. Additionally, field

portable analytical methods and laboratory geochemistry identified three large areas with favourable

chemistry for the formation of lithium pegmatites.

Till Sampling Program

The till sampling program discussed in the exploration update provided on

5 October 2023

was

completed on 26 October 2023. A total of 338 till samples are being processed for pegmatite indicator

minerals, heavy minerals, and geochemical analysis (Figures 5 and 6). The Champion Electric technical

team is testing and comparing two different processing and analytical methodologies. The highlight of

the preliminary results received for 91 samples to date is the presence of spodumene grains in several

till samples at the newly identified Western prospect. One sample returned several thousand spodumene

grains and two fist-sized angular boulders of spodumene. The spodumene grains in the till samples are

dominated by delicate crystals, which would not survive great transport distances. The team is extremely

encouraged by these exceptional results which are evidence of a mineralised system being present

nearby. The interpreted direction of glacial ice movement is from the northeast, as shown on the maps.

The Company controls the mineral rights for tens of kilometres up-ice from this new showing.

The spodumene crystals in the till sample have been confirmed by microscopy, and multiple geologists

have confirmed the spodumene in hand sample. Geologists at the lab also independently confirmed the

largest spodumene boulder by scanning electron microscope (SEM). Small fragments from the

suspected spodumene boulder were glued on a double-sided carbon tape and put into a Zeiss Sigma

300 VP SEM to perform point analyses. The SEM measured the Al

2

O

3

/SiO

2

ratio of the mineral. Even

though conventional energy-dispersive spectrometry (EDS) cannot detect nor quantify lithium,

spodumene has a very specific Al

2

O

3

/SiO

2

ratio, which can only be mismatched with pyrophyllite (a talc-

like mineral). The analysis confirmed that the boulder is composed of spodumene.

The Company is awaiting the reporting of the data from the full till sampling program, which will include

extensive mineralogical data on heavier minerals from within the till. The resulting database will also

include valuable indications of gold, copper, nickel, and zinc that may occur within the large area being

sampled. Silt-sized portions of the samples will also be submitted for geochemical analysis.

Rock Sampling Program

The technical team has now received analytical results for all of the 670 rock samples collected during

the 2023 field season. The results corroborated the field observations and in-field XRF mapping of

magma fractionation trends, indicating the presence of three distinct fertile pegmatite systems with

anomalous Li, Cs, Ta concentrations and favourable rubidium to potassium ratios (Rb:K) in certain

mineral phases. The maximum lithium assay from the program was 0.62% Li

2

O. That sample occurred

approximately 40 km east of the Western prospect in the eastern fractionation trend. The western trend

has been significantly upgraded with the discovery of the spodumene fragments at the Western

prospect, and there are at least two samples along that trend with more than 0.1% Li

2

O.

Geophysics, LiDAR and Plans for 2024

No outcropping bedrock has been identified to date in the area immediately up-ice from the new

Western spodumene discovery. Tailored ground gravity surveys are being planned for early 2024 as a

method to accurately delineate potential blind pegmatite bodies intruding into the metabasaltic host

rocks under shallow cover. Since approximately 75% of the Property is covered by glacial and alluvial

sediments, till sampling and geophysical techniques will be important prospecting tools. Considering the

recent positive results, it is anticipated that systematic till sampling will be conducted over much of the

remainder of the Property in 2024.

The Company has also received the final data from the light detection and ranging (LiDAR) survey and

high-resolution aerial photography. The team is currently processing and interpreting the results so that

new targets can be visited during the 2024 field campaign.

Sampling techniques and QA/QC

Under the supervision of senior staff, samplers collected rock samples from outcrops using rock

hammer, chisel, and sometimes diamond saws. The location for each sample was recorded using a

handheld GPS. Geologists placed the samples in plastic bags with bar-coded sample tags inserted for

identification. The sample bags were gathered into larger rice bags to organize and facilitate transport to

the lab. Champion geologists or contractors maintained secure custody of the samples until transporting

them to Activation Laboraties in in Val d'Or, Quebec for sample preparation and analysis.

Each sample was prepared with the RX1 (crushed and pulverized) method and analyzed after peroxide

fusion using ICP-OES + ICP-MS (Ultratrace-7 method). Champion's QA/QC protocol dictates the

insertion of certified standards and blanks into the sample stream as a check on laboratory quality. The

sample stream also includes blind duplicates every 50 samples. Actlabs also routinely inserts certified

standards, blanks and pulp duplicates as part of their internal QA/QC standard procedure. Results from

these QC samples are also reported.

The results reported herein exhibited satisfactory results from these QA/QC measures.

Qualified Person

Dr. Eric Hebert, P.Geo., Senior Geological consultant, is a member (#0842) of the Ordre des Géologues

du Québec (OGQ) and a qualified person within the meaning of National Instrument 43-101, and has

reviewed and approved the technical information contained in this press release.

Figure 1: Lithium in rock sampling and primary target areas over regional geology (courtesy of

MERN) and satellite topography

To view an enhanced version of this graphic, please visit:

https://images.newsfilecorp.com/files/8681/191407_ad1b4a1ec4bd7947_001full.jpg

Figure 2: Fist-sized angular spodumene boulders retrieved from a till sample at the

Western prospect (courtesy of IOS Services Geoscientifiques)

To view an enhanced version of this graphic, please visit:

https://images.newsfilecorp.com/files/8681/191407_ad1b4a1ec4bd7947_002full.jpg

Figure 3: Grains of spodumene in till sample fraction 0.25 - 0.50mm from the Western prospect

(courtesy of Overburden Drilling Management)

To view an enhanced version of this graphic, please visit:

https://images.newsfilecorp.com/files/8681/191407_ad1b4a1ec4bd7947_003full.jpg

Figure 4: Till sampling locations and preliminary spodumene counts over geology and

topography

To view an enhanced version of this graphic, please visit:

https://images.newsfilecorp.com/files/8681/191407_ad1b4a1ec4bd7947_004full.jpg

About the Project

The Company's lithium properties cover the northern extension of the Lac Guyer Greenstone Belt which

hosts neighboring Patriot Battery Metals' Corvette and

Winsome Resources' Cancet advanced

projects

in the prolific James Bay region of Quebec

(Figure 5).

Figure 5: Champion Electric Lithium Project location map

To view an enhanced version of this graphic, please visit:

https://images.newsfilecorp.com/files/8681/191407_ad1b4a1ec4bd7947_005full.jpg

About Champion Electric Metals Inc.

Champion Electric is a discovery-focused exploration company that is committed to advancing its highly

prospective lithium properties in Quebec, Canada and cobalt properties in Idaho, United States. In

addition, the Company owns the Baner gold project in Idaho County and the Champagne polymetallic

project in Butte County near Arco.

The Company's shares trade on the CSE under the trading symbol "LTHM", on the OTCQB under the

trading symbol "CHELF", and on the Frankfurt Stock Exchange under the symbol "1QB0". Champion

Electric strives to be a responsible environmental steward, stakeholder and contributing citizen to the

local communities where it operates, taking its social license seriously, employing local community

members and service providers at its operations whenever possible.

ON BEHALF OF THE BOARD OF CHAMPION ELECTRIC

"Jonathan Buick"

Jonathan Buick, President and CEO

To learn more, please visit the Company's SEDAR profile at

www.sedarplus.com

or the Company's

corporate website at

www.champem.com

.

For further information, please contact:

Investor Relations and Communications

Phone: (416) 567-9087

Email:

[email protected]

THIS PRESS RELEASE DOES NOT CONSTITUTE AN OFFER TO SELL OR THE SOLICITATION OF

AN OFFER TO BUY ANY SECURITIES IN ANY JURISDICTION, NOR SHALL THERE BE ANY OFFER,

SALE, OR SOLICITATION OF SECURITIES IN ANY STATE IN THE UNITED STATES IN WHICH SUCH

OFFER, SALE, OR SOLICITATION WOULD BE UNLAWFUL.

Cautionary Statements

Neither the Canadian Securities Exchange nor its regulation services provider has reviewed or

accepted responsibility for the adequacy or accuracy of this press release. This press release may

include forward-looking information within the meaning of Canadian securities legislation, concerning

the business of the Company. Forward-looking information is based on certain key expectations and

assumptions made by management of the Company, including closing of the Transactions and the

prospectivity of the Projects for lithium. Although the Company believes that the expectations and

assumptions on which such forward-looking information is based on are reasonable, undue reliance

should not be placed on the forward-looking information because the Company can give no

assurance that they will prove to be correct. Forward-looking statements contained in this press

release are made as of the date of this press release. The Company disclaims any intent or obligation

to update publicly any forward-looking information, whether as a result of new information, future

events or results or otherwise, other than as required by applicable securities laws.

The Projects are at an early stage of exploration, and the Company cautions that the qualified

persons who have reviewed and approved this news release have not verified scientific or technical

information produced by third parties,

To view the source version of this press release, please visit

https://www.newsfilecorp.com/release/191407